automobile pdf manual download also for sable view and download mercury mountaineer owners manual online mercury mountaineer Mercury Mountaineer Owners Manual file PDF Book only if you are registered MERCURY MOUNTAINEER OWNER S MANUAL Pdf Download. [DOWNLOAD] Mercury Mountaineer Owners Manual. Book file PDF easily for everyone and every device. You can download and read.

Author: Dalmaran Tern
Country: Bulgaria
Language: English (Spanish)
Genre: Politics
Published (Last): 4 February 2009
Pages: 142
PDF File Size: 16.3 Mb
ePub File Size: 5.76 Mb
ISBN: 241-6-24058-127-5
Downloads: 13107
Price: Free* [*Free Regsitration Required]
Uploader: Kigalkree

Contents Before driving Introduction Instrumentation Controls and features Seating and safety restraints Starting and driving Starting Driving Roadside emergencies Servicing Maintenance and care Capacities and specifications Customer assistance Reporting safety defects Index All rights reserved.

Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company. Introduction The following warning may be required by California law: Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

During the first 1, km 1, miles of driving, vary speeds frequently. This is recommended to give the moving parts a chance to break in. Introduction These are some of the symbols you may see on your vehicle. Instrumentation Gearshift includes Audio system overdrive button pg. The light may illuminate without a driveability concern being noted. Check the fuel FUEL cap for proper installation. When the fuel filler cap is properly re-installed, the light s will turn off after a period of normal driving.

Refer to Engine coolant temperature gauge, Engine oil pressure gauge or Fuel gauge in this chapter for more information. Instrumentation Turn signal Illuminates when the turn signals or the hazard lights are turned on. If the lights stay on continuously or flash faster, check for a burned-out bulb. High beams Illuminates when the high beam headlamps are turned on. Low washer fluid if equipped Illuminates when the windshield washer fluid is low.

If the light does not come on or the light flashes steadily, have your vehicle serviced as soon as possible, damage to the transmission could occur. Speed control Illuminates when the speed control is activated. Instrumentation Engine coolant temperature gauge Indicates the temperature of the engine coolant. If it enters the red section, the engine is overheating.

2002 Mercury Mountaineer – Owner’s Manual (288 pages)

mounfaineer Stop the vehicle as soon as safely possible, switch off the engine immediately and let the engine cool. Instrumentation Trip odometer Registers the kilometers miles of individual journeys.

Majual and hold the button to reset. Instrumentation Engine oil pressure gauge Indicates engine oil pressure. Instrumentation Usually, when something affects the compass readings, the compass will correct itself after a few days of operating your vehicle in normal conditions.

If the compass still appears to be inaccurate, a manual calibration may be necessary. Refer to Compass calibration adjustment. Instrumentation Compass calibration adjustment Perform this adjustment in an open area free from steel structures and high voltage lines: Info menu This control displays the following control displays: Instrumentation degrees between adjacent zones and will become noticeable as the vehicle crosses multiple zones.


A correct zone setting will eliminate this error. This will take up to three circles to complete calibration. The compass is now calibrated.

Download the Mercury Mountaineer Owners Manual

To operate the Trip Elapsed Drive Time perform the following: System check Selecting this function from the SETUP menu causes the message center to cycle through each of the systems being monitored. Instrumentation Warning messages that have been reset are divided into three categories: Indicates the transmission is overheating.

This warning may appear when towing heavy loads or when driving in a low gear at a high speed for an extended period of time. Stop the vehicle as soon as safely possible, turn off the engine and let it cool. Displayed when the Tire pressure monitoring system is malfunctioning. If the warning stays on or continues to come on, have the system checked by your dealer. Displayed when a Tire pressure sensor is malfunctioning. Displayed when the tire pressure monitoring system is turned off.

Only your dealer can turn the system on owbers off. It is recommended that the tire pressure monitoring system is always turned ON.

Rotate clockwise to the second position to also turn on the headlamps.

Foglamp control if equipped The headlamp control also operates the foglamps. Controls and features High beams Push the lever toward the instrument panel to activate.

Pull the lever towards you to deactivate. Flash to pass Pull toward you slightly to activate and release to deactivate. The autolamp system also keeps the lights on for approximately 20 seconds or a programmed time delay after the ignition switch is turned to the OFF position. Controls and features The RSS detects obstacles within approximately 1. As you move closer to the obstacle, the rate of the tone increases.

Temperature control knob Controls the temperature of the airflow inside the vehicle. Mode selector control Controls the direction of the airflow to the inside of the vehicle. Controls and features Since the air conditioner removes considerable moisture from the air during operation, it is normal if clear water drips on the ground under the air conditioner drain while the system is working and even after you have stopped the vehicle. It can be used to clear ice or fog from the windshield.

For added customer comfort, the system will allow some airflow through the floor ducts in this mode. This will reduce fogging on your windshield. Once the windshield has been cleared, operate the climate control system as desired. Controls and features 4. Set the fan speed to High 5. Direct the outer panel vents towards the side windows 6.

To increase airflow to the outer panel vents, close the central panel vents. Do not place objects on top of the instrument panel, as these objects may become projectiles in a collision or sudden stop. Controls and features mountaineeg window fogging. Additionally, if the engine is not warm enough to provide heat, the fan will operate at a low speed and the airflow will be directed to the windshield or to the floor.

The fan speed will start to increase and the airflow location will change to the floor area. Controls and features Driver side temperature selection DUAL AUTO The display window indicates the selected temperature and manual control of fan speed if automatic fan speed is not desired.


You can override fan speed at any time. To control fan speed manually, press the fan control to cancel the automatic fan speed operation.

Medcury air conditioning compressor can operate in all modes except OFF. Controls and features indicator will not be lit.

Controls and features ducts. For added customer comfort, the air distributed through the floor ducts may be slightly warmer than the air sent to the windshield defroster ducts.

Following this, the outside temperature display will return to the window. The outside temperature reading is most accurate when the vehicle is moving.

Download the Mercury Mountaineer Owners Manual

Controls and features objects may fall down into the defroster outlets and block airflow, in addition to damaging the climate control system. Set the temperature control to full heat 3. To control the auxiliary climate control system from the front controls, turn the fan speed control knob to mabual desired speed.

Controls and features Rear auxiliary climate controls if equipped The rear auxiliary climate controls are located in the headliner of the second row seating.

Ensure that the front auxiliary control is turned to REAR to enable the rear climate mojntaineer. Turn the fan speed control to the desired fan speed. Controls and features Press the mode selector again to select air distribution through the floor vents.

The icon will illuminate on the temperature selector. Only the auxiliary control head front or rear that is active will have the indicator lights functioning. Floor console climate controls if equipped Depending on the equipment package, your vehicle may be equipped with floor console climate control capabilities.

Controls and features Mode selector control Controls the direction of the airflow to the rear of the vehicle. To select air flow from the panel registers of the console, slide the control to. To select airflow from the registers of the floor console, slide the control to To stop mountsineer air from flowing through the floor console: If a selection has been playing for three seconds or more and you pressthe CD will replay that selection from the beginning.

Controls and features 3. Press and hold a memory preset control until the sound returns, indicating the station is held in memory on the control you selected. Press the TREB control then press: Press the FADE control then press: Controls and features Fast forward The fast forward control works in tape and CD modes. Press the COMP control to activate and deactivate compression adjust.

If your vehicle has a separate clock, other than the digital radio displaythe CLK control will not function in the above manner. Turn the control to moountaineer or lower volume.